Is there a fault line in Muntinlupa?
Muntinlupa has the most number of a population exposed to the Valley Fault System, with 8 barangays traversed by the fault, summing up to 483,080 people in total. Massive evacuation might be needed when the effects of the earthquake are at its maximum.
What are the places included in West Valley Fault?
The WVF is approximately 100-km and transects portions of Quezon City, Marikina City, Pasig City, Makati City, Taguig City, Muntinlupa City, and the provinces of Bulacan, Rizal, Laguna, and Cavite.
Where does West Valley Fault start and end?
The Marikina fault line, also known as the West Valley Fault, starts from the Sierra Madre and runs through Bulacan, Rodriguez, Rizal, Quezon City, the eastern side of Metro Manila including Pasig, Taguig, Muntinlupa, San Pedro, and Sta. Rosa in Laguna and ends in Carmona, Cavite.
Is there a fault line in Alabang?
In Muntinlupa City, Alabang is one of the barangays located in the fault line.
Is Muntinlupa prone to earthquake?
Muntinlupa is among seven Metro Manila cities that are earthquake-prone since they lie along the Marikina West Valley Fault.
How far from West Valley Fault is safe?
five meters
But first, what is considered a safe distance from a fault line? PhiVolcs recommends avoiding construction within five meters on each side of a fault trace. This is equivalent to a total width of 10 meters. This is considered the ideal “10-meter wide no-build zone” in the vicinity of a fault.
What is the safest place in West Valley Fault?
Quezon City, Pasay and Manila are some areas which are considered safe from earthquake by many because there are no fault lines discovered in these areas yet.
Where does West Valley Fault start?
But the strong push and pulls were felt to 100 kilometers away, along the broad curve of the 146-kilometer West Valley Fault, which starts from Bulacan in the north and runs through the provinces of Rizal, the Metro Manila cities of Quezon, Marikina, Pasig, Makati, Taguig and Muntinlupa, and the provinces of Cavite and …
Is Muntinlupa safe?
The City of Muntinlupa has been consistent in having low crime rate and is known for its quick response to crises in coordination with the other enforcement offices.
Which part of Philippines has no earthquake?
province of Palawan
Only the province of Palawan appeared to be quake-free among the rest of Philippine territory similar to the previous map. Some people in the comments section noted that Palawan and its neighbor Sulu, which was also seen not affected with earthquakes, were located above a different fault system.
What district is Tunasan Muntinlupa?
1st Legislative district of Muntinlupa
| Tunasan | |
|---|---|
| Region | National Capital Region |
| City | Muntinlupa |
| District | 1st Legislative district of Muntinlupa |
| Established | June 28, 1964 |
Where is the West Valley fault line in the Philippines?
Valley Fault System (VFS) in the Philippines, is a dominantly dextral strike-slip fault system that extends from Dingalan, Aurora in the north and runs through the cities of Quezon, Marikina, Pasig, Makati, Parañaque, Taguig and the provinces of Laguna and Cavite. Download Maps No Registration: PHIVOLCS West Valley Fault Line Google Map,…
Is there a map of the Valley Fault System?
July of last year, we have obtained the Valley Fault System data from PHIVOLCS and traced it along to be presented on an interactive map so the fault line can be visualized on frequently updated basemaps such as on Google Earth’s satellite imagery and OpenStreetMap’s street-level accurate data.
Does a fault line traversing a specific area always cause damage?
It is however noteworthy that there are some areas where even if the fault line traverses, it is still tagged as a low damage probability. This does not automatically depict that the specific area may be exempted from the damage.
What does the lack of structural stability study on the fault line?
It only signifies that it is possible that not enough structural stability studies have been made along the path of the fault line or the fault line data has not yet been established during the time the study was made. The risk map was completed by PHIVOLCS in 2013 while the fault line data was from 2014.