How do I reset my Cisco SG200 26?
Configure your laptop’s network interface to be in the 192.168. 1.1/24 network, but avoid the 192.168. 1.254. Now find a small pin (I used the one from the office stepler) and push into the Reset hole of the switch for about 30 seconds.
How do I setup a managed switch?
Create the VLANs.
- Log in to the management page of the switch.
- Go to Routing – VLAN – VLAN Static Routing Wizard.
- Enter the VLAN ID, the IP Address and the Network Mask for the VLAN.
- Select the ports to add to the VLAN.
- Click Apply.
- When prompted with the Global IP routing mode window, click OK.
How do I Reset my cisco switch to factory settings?
Hold the “mode” button on the front of the switch for 10 seconds. The lights will blink then go solid – the switch completely wipes all configuration and then reboots.
How do I find the IP address of my cisco switch?
Type “show running-config” or “show config” and press the “Enter” key. The IP address or addresses assigned to interfaces on the switch are displayed in the command line interface output.
What is the default IP address of a cisco switch?
192.168.1.254
If there are no DHCP servers available, the switch will use its factory default IP address which is 192.168. 1.254.
Do you need to set up a managed switch?
While they may require a more substantial setup, managed switches also boast many added features such as redundancy procedures or data recovery solutions. Be warned that unlike most unmanaged switches, these devices will often require an IT professional to be set up and managed properly.
Do I have to set up a managed switch?
The short answer is no. There is no fundamental difference in speed between managed and unmanaged switches. However, it is important to note that a managed switch provides significantly better overall network performance, which tends to enhance speed in the long run.
What is my Cisco username?
cisco
The default username is cisco. The default password is cisco. Usernames and passwords are case sensitive.
How do I configure a second VLAN for the sg200-26?
tk, The SG200-26 is a Layer 2 switch and can only have a single management IP. You cannot configure a second IP for VLAN 2. To change the VLAN assigned to a port, browse to VLAN Management-> Port to VLAN. Select VLAN ID 2 from the dropdown at the top and press “Go” to the right.
Does the sg200 switch support multiple subnets?
Hi TK Lam, what you’re trying to do is very adminstrative intensive and not the most ideal. SG200 switch supports VLAN but it does not support routed VLAN. RV042 router supports multiple subnet but not DHCP for multiple subnet.
How to configure a 200/300 series managed switch?
One way to configure your switch is with the graphical user interface or GUI. This article explains how to access the GUI and configure the IP address of a 200/300 Series Managed Switch. Step 1. Connect the switch to a power supply to turn it on. The switch accepts voltage in the range of 100-240V. Step 2.
How do I login to my Cisco managed switch?
Enter the IP address of the switch in the address bar and press Enter. The Managed Switch Login page opens: Step 6. Enter the username in the Username field. The default username is cisco. Step 7. Enter the password in the Password field. The default password is cisco. Passwords are case sensitive. Step 8.